ASTM D3776 PDF

Terminology 3. Current edition approved April 10, Published June Replaces Sections 35 to 41 of Methods D — 64

Author:Voodoora Tobei
Country:Jamaica
Language:English (Spanish)
Genre:History
Published (Last):16 September 2014
Pages:456
PDF File Size:16.24 Mb
ePub File Size:9.55 Mb
ISBN:231-6-55735-875-1
Downloads:92230
Price:Free* [*Free Regsitration Required]
Uploader:Bragal



More D Option A may be used for acceptance testing of commercial shipments since it has been used extensively in the trade. The second option is Option B which is applicable to a full-width sample cut from a full piece, roll, bolt, or cut. Unless otherwise specified, these results will include selvages and will be on the basis of conditioned fabric. Option C on the other hand is applicable when a small swatch of fabric is sent to the laboratory to be used as the test specimen.

The results are considered to be applicable to the sample only and not necessarily to the lot from which the sample was taken. Measurements by this method do not include selvages and should be reported as such, unless a selvage allowance is specified.

The last option is Option D which is intended for use with narrow fabrics as so designated by the trade. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Scope 1. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

Combining values from the two systems may result in non-conformance with the standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

M2N-VM DVI MANUAL PDF

ASTM D 3776 Standard Test Method for Mass Per Unit Area (Weight) of Fabric1

Standards Subsctiption may be the perfect solution. Two operators in each laboratory each tested two specimens of each material for mass per unit area. In this procedure the complete laboratory sample is used as the specimen. Combining values from the two systems may result in non-conformance with the standard. Proceed to Checkout Continue Shopping. Competent statistical assistance is recommended for the investigation of bias. Consider the rolls of fabric in the lot sample as the laboratory sample and as the test specimens.

CONVERSOR DE ARQUIVO TKL PARA PDF

Popular Publishers

More D Option A may be used for acceptance testing of commercial shipments since it has been used extensively in the trade. The second option is Option B which is applicable to a full-width sample cut from a full piece, roll, bolt, or cut. Unless otherwise specified, these results will include selvages and will be on the basis of conditioned fabric. Option C on the other hand is applicable when a small swatch of fabric is sent to the laboratory to be used as the test specimen. The results are considered to be applicable to the sample only and not necessarily to the lot from which the sample was taken.

Related Articles